塑料水管探測儀 型號:ZD2RD500 | 貨號: |
內容簡介: ZD2RD500塑料水管探測儀 ZD2RD500是探測塑料自來水管道最的設備,ZD2RD500塑料水管探測儀由發射機和手持式的接收機組成。發射機在消防栓、水表底座或水龍頭上給塑料管道施加一個特殊的壓力波信號,接收機的地震波傳感器接收該信號,從而對塑料管道進行定位。 ■表頭和聲音信號指示 ■開機電池狀況檢測 ■便攜式,重量輕 ■定位精度:埋深的5%(埋深2米時) 2.0 Fast Start Guide:Detailed operating instructions are also included on the side of the Receiver. These instructions are repeated her for your convenience:Transmitter Operating Instructions:1. Remove protective caps from transmitter2. Connect transmitter to nearest water outlet using kit supplied with transmitter3. Turn on waterloosen adjustment lock nut near T-handle4. Turn T-handle clockwise until water fl ows5. Turn T-handle counterclockwise until water pulses several times per second; tighten lock nutReceiver Operating Instructions:1. Turn ON/OFF knob clockwise to activate2. Initial meter reading indicates battery condition3. To replace battery, loosen battery release button, move housing upward to expose battery4. Begin initial tracing about 2 meters from transmitter or any other area where pipe location is known5. Push spike of receiver into ground near known pipe locationturn ON/OFF knob clockwise for mid-range meter readingadjust individual headphone controls for comfortable listening level6. To pinpoint pipe position, use receiver to probe ground until you fi nd peak maximum meter reading. You will also hear the pulsing sound similar to a heartbeat grow louder7. Trace the pipe by establishing the direction of pipe route by probing every one to two meters to locate a peak meter reading. Adjust the ON/OFF knob to maintain a mid-range meter readingNotesPrecautions:The ZD2RD500 is for use on water pipes only It works best on water pressures in the range of 3 to 7 Bars; maximum pressure 10 BarsThe Transmitter pulsating effect causes pipe movement. If used for extended periods or on substandard plumbing systems, leaks may resultAdditional NotesPrecautions:1. ZD2RD500 readings do not indicate depththe ZD2RD500 does not detect buried electrical power lines, gas lines or other hazardous underground objects, so always dig carefully in the proximity of buried pipes or cables2. Use caution while wearing headphonesbe alert to traffi c or other hazards that are normally heard outdoors3. Always stand clear of all transmitters, adapter kitshoses while they are connected to water systemsoperating4. On all hose bib applications, within 15 meters 50 feet of a building, the proper low-power transmitter GREENfaucet damper MUST MUST be used3.0 Transmitter Application Techniques:Transmitters are connected at sprinkler heads, hose bibs, water meter bases, fi re hydrantsclean-outs. Supplied transmitter adapter kits are illustrated in Section 5.0 of the OperationalManual. Always fl use any connection site until the water that fl ows is clear of all rust, silt, sealing compoundsforeign materials before connecting a transmitter to the water line.Refer to Section 5.0 for a detailed description of the receiver kitthe adapter kits that are available. All adapter kits are supplied with a 3-meter 10 foot high-pressure drain hose that must be connected to the outlet of the transmitter in order for the device to work properly.Always use a weight on the hose or tie the hose down to prevent the hose from whipping.Check the water pressure before attempting to locate the water linemake sure that it is in the operating range of the transmitter, which is 3 to 10 Bars 40 to 140 psi.4.0 Receiver Application Techniques:Two devices are provided for probing the surface with the ZD2RD500 receiver. A 14cm 5.5 inch ground spike is supplied for soft surfacesa brass hard surface plate is included for hard surfaces such as concrete or tarmac asphalt. The hard surface plate has concentric recessed channels in its surface that allow it to be positioned such that it lays fl at against surfaces.The ZD2RD500 is supplied with high quality headphones that have independent volume adjustments on each ear piece. Using non-standard headphones may reduce system performance; create oscillation in the audio outputcause mechanical damage to the headphone jack.Pinpointing pipe location is difficult without using the meter to measure signal level. It is very difficult for the average person to discern slight variations in audio signal levels. Always adjust the sensitivity so as to maintain a mid-scale meter reading while locating. Typical location accuracy is plus or minus one pipe diameter. Always probe or expose the pipe to confirm the exact location before performing any excavation.Best location results are obtained by beginning your tracing at least 3 meters 10 feet from the location where the transmitter is connected. The signal levels are normally too strong in the area immediately surrounding the transmitter. Alternately, tracing may begin at a known pipe location that is not more than 75 meters 250 feet down the pipe from the transmitter.The preferred method for tracing pipes is to locate at least two known pipe locations that indicate the heading or direction that the pipe is laid. Readings should be taken along an imaginary line that runs perpendicular to the pipeline. Confirm a peak signal reading by taking additional readings that are equal distances from the peak location. These readings should be lower than the peak readingapproximately equal.Once the pipe direction is determined, it is possible to quickly trace the pipe along this headingconfirm any changes in direction by periodically taking readings.Always transportstore your receiver in the carrying case to protect it from damage. If the receiver is allowed to fall overstrike a hard surface it may permanently damage the meter.5.0 ReceiverAdapter Kit Details:The receiver kit, sprinkler/hose bib kit, fire hydrant kitwater meter kit details are supplied for your reference in identifyingmaintaining the equipment.5.1 Receiver Kit Details: | 產品圖片 |
鉆孔取芯時會經常碰到混凝土內金屬而損壞鉆頭,影響工作,SCANNER金屬探測儀是避開混凝土內鋼筋及其它金屬工具,它不僅能檢測到混凝土內金屬的位置,同時可估測金屬覆蓋層的厚度并能區分探測到的物體是磁性物質還是非磁性物質,該機采用內置探頭,主機與探頭連為一體,結構緊湊,檢測到鋼筋便自動蜂鳴報警,最大探測深度達150㎜,定位,是鉆孔取樣的必備工具。
型號:RL061388GTI2500地下金屬探測器 | 型號:RL061419地下金屬探測器探寶儀器LASER | 型號:RL061403GS500地下金屬探測儀器 |
真正可視的地下金屬探測器探寶儀器LASER
隨后進入加載頁面 :
在進入中英語選擇頁面,可以直接觸碰屏幕上的中英文圖標選擇工作語言。
在進入中英文選擇頁面,可以直接觸碰屏幕上的中英文圖標選擇工作語言。
選擇一種語言進入待機界面后,掃描指針呈周期性掃動,如圖
欄目頁面:http://www.runlian365.com/chanpin/6551.html可視地下探寶器來源網址:http://www.runlian365.com/chanpin/did-61419-pid-6551.html地下金屬探測器探寶儀器LASER型號:RL061403GS500地下金屬探測儀器GS500使用的供電方式是:優質的可充電電瓶
12V優質的可充電電瓶 PK 傳統9V干電池
供電方式 | 12V優質的可充電電瓶 | 傳統9V干電池 |
使用壽命 | 2年以上 | 一次性 |
工作時間 | 電池充滿電,可連續工作12小時以上,間斷性工作可達24小時以上 | 工作2小時后,電壓開始降低 |
探測深度 | 保證長時間不受電量變化影響 | 電壓下降開始衰減,影響探測效果 |
使用成本 | 使用成本幾乎為零 | 每年高達上千元電池更換成本,且太不符合環保要求了 |
光時域反射儀,紅光筆,OTDR電池,光纖識別器,蓄電池,開纜刀,路由探測儀
(一)光時域反射儀:橫河AQ7270;EXFO FTB-200B;安立MT9081D OTDR;
(二)美國波士頓紅光筆,臺灣捷耀紅光筆;
(三)熔接機電池,OTDR電池,熔接機適配器,熔接機加熱器;
(四)熔接機后備電源,交直流移動電源;
(五)光纖識別器OFI400;
(六)縱向雙邊開纜刀;
(七)美國3M路由探測儀;
聯系人:蔡志平 13925252005 0755-82905858 www.willsoon.cn QQ:444085058
1. 機芯采用進口,使本機具有極高的靈敏度.2. 探頭上發光管可指示出斷針位置.3. 自動計數器記錄被檢物的數量,靈敏度為六級可調.4. 靈敏度為無級可調,磁場干擾顯示.5. 當檢測到斷針或鐵類物,聲光儀表同時報警,輸送帶返回或停止.龍門式金屬探測儀(標準型)龍門式金屬探測儀(雙龍門型)
探測項目 | 所有 |
靈敏度可調功能 | √ |
電源指示燈 | √ |
LED指示泄漏量 | √ |
快速預熱 | √ |
最大靈敏度 | 5ppm |
低電顯示功能 | √ |
Times采用泵降低響應時間 | √ |
快速反應 | √ |
可調探測控制 | √ |
配備較長的柔性不銹鋼探頭探測所有區域 | √ |
供電 | 4.8v鎳鉻可充電電池組 |
產品顏色 | 紅 |
產品凈重 | 613.5g |
產品尺寸 | 234.5*86*46mm |
包裝方式 | 吸塑 |
標準外箱容量 | 20 |
標準外箱尺寸 | 50.5*37.1*33.2cm |
標準外箱毛重 | 15.8Kg |
歡迎來到山東創惠電子科技股份有限公司網站,http://www.sdchgroup.cn/index.php 具體地址是山東煙臺高新區中俄產業園。 聯系電話是,聯系手機是15563841125,主要經營本公司是專門從事安全防范產品的研發、生產和銷售的高新技術企業。公司坐落于中國山東省煙臺市,歡迎惠顧! 本公司主營執法記錄儀、審訊主機、視頻會議、無線通信管控等產品,秉承“客戶至上,品質優先”的理念,矢志以先進的技術、優質的產品、完美的服務為客戶創造更多的價值。歡迎廣大客戶來電咨詢!